7-WAY CONNECTOR UNPLUGS

Discussion in 'General RVing' started by abuchta, Jan 28, 2002.

  1. abuchta

    abuchta New Member

    I had the unhappy experience of have my Bargman 7-way connector unplu
    while towing my 30' 5th wheel. How can I prevent this from happeneing again?? I know I plugged it in good at the start of the trip.
    Are there better plugs or a cure to this problem?? Help.


    Edited by - abuchta on Feb 21 2002 2:28:00 PM
     
  2. rv wizard

    rv wizard New Member

    7-WAY CONNECTOR UNPLUGS

    If you have a hinged cover for the receptacle you could tape the plug around the receptacle cover to hold it into place.

    Mike, Amy, Ashley, Candi
    '95 Rexhall 36' Aerbus
    #3 & #8 NASCAR
     
  3. Vern M

    Vern M New Member

    7-WAY CONNECTOR UNPLUGS

    I always secure mine with a wire tie wrapped around the back of the lid down across the plug behind its two tabs. That secures it just fine.

    Vern M.
     
  4. abuchta

    abuchta New Member

    7-WAY CONNECTOR UNPLUGS

    try wrapping one of those plastic zip locks around the lid and the plug. after you tighten it up - it will stay in real good.
     
  5. abuchta

    abuchta New Member

    7-WAY CONNECTOR UNPLUGS

    the last reply was a test to see if the reply service was working ab
     
  6. drummerman

    drummerman New Member

    7-WAY CONNECTOR UNPLUGS

    Those small 6 inch elastic tie downs work great. I wrap one around my plug, and have never had it come loose.

    Drummeramn
     

Share This Page