I have had "Professionals" tell me to completely replace my motor and hydraluic pump unit. I bought the appropriate kit that even came with the hydraluic reservior.
Unit will still not retract.
We just returned from a 1500 mile trip from Atlanta GA to Colorado Springs and experienced extreme temperature and altitude changes and had no issues.
Parked to clean it up, put out the slide out and now it will not come in.
I have been trying everything and then noticed something that did not look right. The two braces that go between the frame of the RV and the edge of the slide out did not look the same. The front of the slide out were nice and straigt, but the rear of the slide out look bent. Pics included.
Any advice?
Any advice. Is it possible that the slide out is canted and not able to roll in straight. I am a noob so please be kind.
Unit will still not retract.
We just returned from a 1500 mile trip from Atlanta GA to Colorado Springs and experienced extreme temperature and altitude changes and had no issues.
Parked to clean it up, put out the slide out and now it will not come in.
I have been trying everything and then noticed something that did not look right. The two braces that go between the frame of the RV and the edge of the slide out did not look the same. The front of the slide out were nice and straigt, but the rear of the slide out look bent. Pics included.
Any advice?
Any advice. Is it possible that the slide out is canted and not able to roll in straight. I am a noob so please be kind.