DL Rupper
Senior Member
Hey folks I'm embarrased to ask but, my roof vent lid was damaged/broke back in Mar during a Georgia hail storm. I taped it with duct tape and got by until today. I bought a new vent lid and tried to replace my old one, however, I can't get the old one off.
The instructions say:
Crank vent lid to full open position.
Release the operator arm roller from lid slide bar, slide lid side-ways off of vent base.
My problem is that I can't get the operator arm roller to release. It flat won't open far enough for the round roller tab to reach the enlarged round hole in the slide bar. Is there some kind of release trick I'm missing?
Frustrated in Nebraska. :dead:
The instructions say:
Crank vent lid to full open position.
Release the operator arm roller from lid slide bar, slide lid side-ways off of vent base.
My problem is that I can't get the operator arm roller to release. It flat won't open far enough for the round roller tab to reach the enlarged round hole in the slide bar. Is there some kind of release trick I'm missing?
Frustrated in Nebraska. :dead: